YAMAHA V-STAR 650 CA SHORTSHOTS STAGGERED INSTALLATION MANUAL
download Check condition of stock exhaust gasket. Replace if damaged or worn. 2. Install mounting bracket (stamped 384-P) in the original bracket mounting position using two 8mm bolts (supplied)(Figure...
View ArticleHARLEY DAVIDSON AUTOMATIC COMPRESSION RELEASE TOOLS INSTALLATION MANUAL
download INSTALLATION Compressed air can pierce the skin and flying debris from compressed air could cause serious eye injury. Wear safety glasses when working with compressed air. Never use your hand...
View ArticleYAMAHA V-STAR 650 EXHAUST SYSTEM REMOVAL AND INSTALLATION
download REMOVING THE STOCK EXHAUST SYSTEM 1. Remove the right hand frame cover to avoid scratching it. 2. Remove the nuts that mount the rear header to the cylinder head. 3. Loosen the pinch clamp on...
View ArticleDucati Sport Clutch Lever INSTALLATION INSTRUCTIONS
download 1 To remove your stock lever, use a 19mm wrench or (adjustable wrench) to remove the large sheet metal nut attached to the main pivot bolt that holds the lever. (Photo 1a) Once the locknut is...
View ArticleHARLEY DAVIDSON REAR SWINGARM AXLE COVER KIT INSTALLATION MANUAL
download INSTALLATION Perform this installation when the engine is cool. Working on or near the exhaust system when the engine is hot could result in severe burns. (00311a) NOTE XL Sportster 883 and...
View ArticleHARLEY DAVIDSON PIVOT BOLT COVER INSTALLATION MANUAL
download This kit fits all 2004 and later XL (Sportster®) model motorcycles INSTALLATION Right-Side Pivot Bolt Cover Installation Perform this installation when the engine is cool. Working on or near...
View ArticleHARLEY DAVIDSON GLOSS BLACK HEAD BOLT COVERS INSTALLATION MANUAL
download This kit fits 1992 and later Evolution 1340 and XL models and 1999 and later Twin Cam-equipped models. INSTALLATION Perform this installation when the engine is cool. Working on or near the...
View ArticleYAMAHA VIRAGO 700/ 1100 2 into 2 EXHAUST SYSTEM REMOVAL AND INSTALLATION MANUAL
download REMOVING THE STOCK EXHAUST SYSTEM 1. Loosen the slip joint clamp on the front and rear head pipe, which are located at the muffler box. 2. Remove the two nuts that hold the front head pipe to...
View ArticleYamaha Road Star 1600/ 1700 Exhaust kit bill of materials Installation...
download 1. Remove left side cover, by removing allen bolt as shown (Fig 1). Once bolt is removed, push cover to motor and push back carefully to your upper body. Figure 1 2. Once left side cover is...
View Article1981-1983 Yamaha Virago 750 & 920 Installation Instructions
download Start by loosening the rear cylinder down tube bolt located on the top of the old mufflers center collector in front of the rear tire. 2. Remove both of the front cylinder exhaust pipe head...
View Article
More Pages to Explore .....